This adds expire and unlink fields to the PublicLink interface.
This fixes up the affected backends and removes unlink parameters
where they are present.
Before this change the exit code for transfer limit exceeded was
incorrect. This was because the `resolveExitCode` function unwraps the
error thus reading the underlying error which is not the same as the
error it was comparing to (`ErrorMaxTransferLimitReached`).
This change fixes it by splitting the error definition in two so that
when the Fatal error is unwrapped we match against
`ErrorMaxTransferLimitReached` however when we return the error we
return `ErrorMaxTransferLimitReachedFatal`.
Statistics of ransfers which were interrupted are not cleared before
retry iteration. These transfers completed with over 100 percentage.
This change clears transfer accounting before next retry iteration is
done in order to keep numbers in track.
Fixes#3861
For few commands, RClone counts a error multiple times. This was fixed by
creating a new error type which keeps a flag to remember if the error has
already been counted or not. The CountError function now wraps the original
error eith the above new error type and returns it.
Before this change --update would transfer any file which was newer
than the destination regardless of whether it had changed or not.
This is needlessly wasteful of bandwidth.
After this change --update will only transfer files if they are newer
**and** they are different (checked with checksum and size).
'Couldn't find file - Need to Transfer' changed to 'Need to transfer -
File Not Found at Destination' because while reading the debug logs, it
confuses with failure in operation.
Before this change if -u/--update was in effect we compared the size
of the files to see if the transfer should go ahead. This was
comparing -1 with an actual size so the transfer always proceeded.
After this change we use the existing `sizeDiffers` function which
does the correct comparison with -1 for files of unknown length.
See: https://forum.rclone.org/t/sync-with-google-photos-to-local-drive-will-result-in-recoping/11605
Before this change we didn't calculate or check hashes of transferred
files if --size-only mode was explicitly set.
This problem was introduced in 20da3e6352 which was released with v1.37
After this change hashes are checked for all transfers unless
--ignore-checksums is set.
Before this change we calculated the checkums when using
--ignore-checksum but ignored them at the end.
Now we don't calculate the checksums at all which is more efficient.
Before this change for a post copy Hash check we would run the hashes sequentially.
Now we run the hashes in parallel for a useful speedup.
Note that this refactors the hash check in Copy to use the standard
hash checking routine.
Before this fix rclone calculated all the hashes on transfer. This
was particularly slow for the local backend.
After the fix we just calculate one hash which is enough for data
integrity.
This was factored from fstest as we were including the testing
enviroment into the main binary because of it.
This was causing opening the browser to fail because of 8243ff8bc8.
